A furnace that won't light or keeps shutting off needs real diagnosis, not another reset. Every visit includes a carbon monoxide safety check, standard, not an upsell.
Furnace failures in Wellington cluster around a handful of parts — ignitors, flame sensors, gas valves, heat exchangers. We test with real equipment, not parts-cannon guessing.
What doesn't change from visit to visit.
A combustion analyzer reading for dangerous CO levels is part of every visit, not optional.
We bump no-heat calls ahead of routine visits when it's cold.
Ignitor or heat exchanger, the price is quoted and approved before work begins.
Both fuel types get the same trained tech, no exceptions.
The most common furnace failure points.
These two parts are behind most no-heat visits, usually a same-visit fix.
Gas valve testing confirms the fault before we recommend replacing it.
A cracked heat exchanger can leak combustion byproducts into the airflow — we inspect with a scope and analyzer rather than assuming based on age.
We test both before condemning the control board.
Older Wellington furnaces with standing pilots have their own failure points — thermocouples, pilot orifices, draft issues that newer ignition doesn't have.
Zero response from the furnace can mean a wiring fault, not a furnace failure to avoid overcharging for parts you don't need.
Four steps, safety checked at every one.
Describe the symptom and we route the nearest tech and we'll get someone moving.
Truck arrives stocked with common ignitor, flame sensor, and control parts ready to diagnose and often repair same visit.
Combustion analysis happens before any repair is quoted, then a flat-rate quote.
Most repairs finish same visit, with a final CO check before we leave, backed by warranty.
Recent reviews from winter heating calls.
Pilot light kept going out on our older furnace every few days. Tech identified a failing thermocouple that two other companies had overlooked.
— H. Delacroix, homeowner
Furnace made a loud bang on startup that scared the whole family. Turned out to be a delayed ignition issue from a dirty burner, cleaned and resolved same visit.
— F. Ibekwe, homeowner
Called about a gas smell near the furnace closet and they had someone here within the hour to confirm it was safe before doing any repair work.
— Q. Whitmore, homeowner
Landlord here with an older building, they've kept three separate furnace units running through two winters without a single emergency callout.
— Z. Andreou, landlord
What Wellington customers ask most.
We always confirm with a proper reading before quoting.
It's a real safety concern, taken seriously.
A CO check is standard on every call, no upcharge.
Yes — thermocouple and draft-related repairs are covered.
We prioritize no-heat situations even during high demand.
Common parts are stocked, rare ones may need next-day ordering to finish the repair.
Our furnace repair coverage spans Wellington and nearby Wellington, TX zips below — call to confirm.
Call +1-844-611-2875
